11m Street and Road Lighting Pole - Gutman, type 11003

• Mast Heights: 3 m - 15 m
• Type: Single sheet polygon up to 12m, additional extension after 12m
  
• Materials: St 37 - S235JR - EN 10025
  
• Ground Fixing: Ground Flange for easy fixing

• Surface Protection: Hot Dip Galvanized EN ISO 1416
• Surface Coating: Electrostatic Powder Coating (Optional)
• Bolt/Nut: ISO 898.1/5.8

• Streets and Roads
• Intercity / Interstate Highways
• Parking lots
• Airports
• Ports
• Highways
• Parks and Gardens
• Walking Path / Running Tracks
• Construction and Mining Sites

• Squares / Agora
• Industrial areas
• Sports Fields
• Arenas
• Open Campus / Recreation Areas
• Military District
• Junctions
• Intra-Site Compound Sites
• Wildlife Zones

Height of the poles to be used in the lighting pole project to be applied

The street lighting pole must be at the correct height to ensure the appropriate lighting intensity. In most cases, street post heights range from 3 to 15 meters. Ideally, a lighting pole should provide enough light without excessive glare.

Lighting consistency and installation intervals

In addition to increasing the feeling of safety, lampposts are meant to illuminate the road for pedestrians, cyclists and drivers and keep them safe. However, if an area is well lit and the adjacent area is pitch dark, it can cause accidents as it takes some time for the eyes to adjust. In order to avoid such problems, lighting poles should be designed and placed at regular intervals.

Environment to be implemented

It is necessary to pay attention to the area where street and street lighting poles are applied. For example, in a coastal area, the poles are susceptible to corrosion from salt water. Therefore, you need poles with special coatings and special materials.

Light distribution

Although a street can be well lit by lampposts, there are factors such as trees or tall buildings that can create dark spots. It is very important to consider such features when designing how the lighting poles will be placed.

• The flexural strength of the material is >=235n/mm² for Q235, S235 and SS400, and the minimum flexural strength is >=345n/mm² for Q345 S355 and Gr 50.
• The pole shape can be Polygon, Round, Conical Octagon, Conical round, Round conical, Conical Square, Square shapes.
• Arm type It can be produced as Single arm, Double arm, Three arm, Four arm shapes.
• 42mm, 48mm, 60mm, 76mm etc. It can fit any lamp of any diameter.
• Advanced CNC welding equipment. The defect test has been applied, and the shape of the weld is beautified thanks to the internal and external double welding. International welding standards are applied.
• Hot dip galvanizing application with an average thickness of 80-100µm in accordance with European standards.

• The pole color can be dyed according to the color card or according to the customer's needs.
• Hot dip galvanizing can be done with powder paint.
• Wind pressure resistance level from 100Km/h to 105Km/h and matching customer design.
• The base plate is square, octagonal or round in size, with slotted holes drilled for the anchor bolt and according to customer's requirement.
• Underground recessed installation in length according to customer's requirement.
• Quality control was carried out according to ISO9001-2008 requirements.
• Less land occupation and easy maintenance.